I’d like to cut a Rectangle at 30x30mm,
however, it become 30×60.2 in simulation and in laser,
Please make sure “Enable rotate engrave” is not ticked.
Popular Pages
Home » troubleshooting » Wrong proportions from RDWorks
Related Posts
07
Dec,2016
There are three cases.
1. Two sides of the working table are not of the same height.
Turn off the whole.
06
Dec,2016
Some point of the same piece of materials cannot be cut through, why?
This problem is mainly caused by following.
29
Nov,2016
Following reasons cause the failure of laser working (has no laser beam)
1. Cooling system problem (includes water chiller)
2. Laser.
28
Nov,2016
1. Please check if the rotary switch is turned on,like below:
PS: Turning to "O" off means all is normal.
If.
23
Nov,2016
This problem may cause from improper setting of the software.
Please start up the laser software RDWorksV8. And then click.
21
Nov,2016
If the file being imported is DXF format, the problem may be caused by improper software setting.
For example, the.
17
Nov,2016
If there are several USB interfaces with your PC, it's able for one PC (laser software) to connect with.
11
Nov,2016
1. Firstly run CorelDraw and set the parameter following below instructions:
2. After that, close CorelDraw. Double click to open.
10
Nov,2016
1. RDWorks cannot read PDF and open it directly.
2. Use CorelDraw to open/import PDF file. Then save the graphic.
19
May,2016
If your laser cutter’s LCD panel is in Chinese,it might cost you lots of time to set to English.Now.
19
May,2016
As long as your door is wider than 740mm, you can divide your thunder laser cutter into two parts.
19
May,2016
If the software shows the below information:
Please try the following solutions:
A.Please check if the USB cable is loose or.