Laser cutter's LCD panel in Chinese

Home » troubleshooting » Laser cutter’s LCD panel in Chinese

If your laser cutter’s LCD panel is in Chinese,it might cost you lots of time to set to English.Now Thunder laser will show you how to change Chinese to English just in a few seconds.

Step 1. click “Z/U” button

Step 2. select “语言设置”and then press “Enter” to confirm

Step 3. select “英文”and press “Enter” to confirm

Now it’s in English

Dec,2016

How to calibrate the working table to level.

There are three cases. 1. Two sides of the working table are not of the same height. Turn off the whole.

Dec,2016

Some point of the same piece of materials can not be cut through, why

Some point of the same piece of materials cannot be cut through, why? This problem is mainly caused by following.

Nov,2016

Why the laser has no laser beam?

Following reasons cause the failure of laser working (has no laser beam) 1. Cooling system problem (includes water chiller) 2. Laser.

Nov,2016

Why the Y axis cannot work suddenly?

1. Please check if the rotary switch is turned on,like below: PS: Turning to "O" off means all is normal. If.

Nov,2016

Why does the cutting and engraving graphics reverse (mirror)

This problem may cause from improper setting of the software. Please start up the laser software RDWorksV8. And then click.

Nov,2016

Why does the graphic size that imported to RDWorks different from its original size

If the file being imported is DXF format, the problem may be caused by improper software setting. For example, the.

Nov,2016

How to run several laser machines with one PC

If there are several USB interfaces with your PC, it's able for one PC (laser software) to connect with.

Nov,2016

How to install the CorelDraw plugin for RDWorks

1. Firstly run CorelDraw and set the parameter following below instructions: 2. After that, close CorelDraw. Double click to open.

Nov,2016

How to import PDF files into RDWorks

1. RDWorks cannot read PDF and open it directly. 2. Use CorelDraw to open/import PDF file. Then save the graphic.

Jul,2016

Wrong proportions from RDWorks

I'd like to cut a Rectangle at 30x30mm, however, it become 30x60.2 in simulation and in laser, Please make sure.

May,2016

My door is too narrow (only 80CM wide), how to move the laser cutter into my house?

As long as your door is wider than 740mm, you can divide your thunder laser cutter into two parts.

May,2016

The computer can’t identify the laser cutting machine

If the software shows the below information: Please try the following solutions: A.Please check if the USB cable is loose or.

Related Posts