Alarm message of LCD panel—Water error

Home » laser cutter machine » Alarm message of LCD panel—Water error

LCD panel shows the following information:
some trouble of laser engraver
Here are the reasons:

● Water chiller（water pump）is not turned on

Please turn on the water chiller before power on the machine, like below.
some trouble of laser engraver

● Signal cable for water protection has no connection

Please has signal cable connected, like below.
some trouble of laser engraver

● Wiring problem

Please check it according to the video below.

End.

Jun,2019

Here are the reasons: ● The red dot pointer is off Locate on the Red Dot Pointer Mount in.

Jun,2019

Chiller lcd panel is showing normal, but the red light on and buzzer beeping. Here are the.

Jun,2019

Here are the reasons: ● Air compressor break down How to check if air compressor break down, there’s a.

Jun,2019

Here are the reasons: ● Exhaust fan break down How to check if exhaust fan break down, there’s a.

Jun,2019

Here are the reasons: ● The needed focus is lost The bending of the material.

Jun,2019

Here are the reasons: ● The needed focus is lost The bending of the material or the.

Jun,2019

Here are the reasons: ● The laser switch is off Please make sure laser switch is on, then open.

Nov,2018

Here are the reasons: ● X-axis limit switch problem Locate on the left side of x-axis, please check if.

Nov,2018

Here are the reasons: ● Rotary switch is turned on Note: The rotary-axis and y-axis can be switched, if.

Nov,2018

LCD panel shows the following information: Our machine has sensors for door protection (front.

Nov,2018

LCD panel shows the following information: This problem only appears on engraving mode, it’s.

Nov,2018

LCD panel shows the following information: Here are the reasons: ● The size of the graphic.

Related Posts